Motion Technology Motors

Gearheads

GEARHEADS The primary reason to use a gearhead is that it makes it possible to control a large load inertia with a comparatively small motor inertia. Moog offers a selection of windings in each frame size that, combined with a selection of reduction ratios, offers an assortment of solution to output requirements. Precision Planetary Gearheads

SHAFT INERTIA gcm 2

MODEL

AVAILABLE RATIOS

NUMBER OF STAGES

OUTPUTTORQUE

32 mm (1.26 inch Diameter) Low Cost

4:1 (3.70:1) to 308:1 (307.54:1)

0.40 to 2.0 Nm (56.6 to 283.2 oz-in)

1 to 3

1.35 to 0.89

4:1 (3.70:1) to 308:1 (307.54:1)

32 mm (1.26 inch Diameter)

0.75 to 4.5 Nm (106.2 to 637.3 oz-in)

1 to 3

1.54 to 0.96

4:1 (3.70:1) to 308:1 (307.54:1)

52 mm (2.05 inch Diameter)

4.0 to 25.0 Nm (2.95 to 18.4 ft-lbs)

1 to 3

16.57 to 9.21

4:1 (3.70:1) to 308:1 (307.54:1)

62 mm (2.44 inch Diameter)

8.0 to 50.0 Nm (5.90 to 36.88 ft-lbs)

1 to 3

0.037 to 0.017

4:1 (3.70:1) to 308:1 (307.54:1)

81 mm (3.19 inch Diameter)

20.0 to 120.0 Nm (14.75 to 88.50 ft-lbs)

1 to 3

0.165 to 0.089

4:1 (3.70:1) to 308:1 (307.54:1)

120 mm (4.72 inch Diameter)

50.0 to 300.0 Nm (36.88 to 221.3 ft-lbs)

1 to 3

1.112 to 0.519

Moog has offices around the world. For more information or the office nearest you, contact us online. contactus@moog.com Moog is a registered trademark of Moog Inc. and its subsidiaries. All trademarks as indicated herein are the property of Moog Inc. and its subsidiaries. ©2019 Moog Inc. All rights reserved. All changes are reserved. Motion Technology Motor Product Guide MS3341 10/19

For product information, visit www.moog.com

This technical data is based on current available information and is subject to change at any time. Specifications for specific systems or applications may vary.

www.moog.com

Made with FlippingBook - Online catalogs