2018-Navigator-Owners-Manual

Towing

Calibration The system monitors various vehicle parameters to ensure your vehicle is being driven straight and the trailer straight behind your vehicle. Any steering input or trailer movement will pause the calibration. For best results: • Use a long, straight, smooth and level road when attempting to calibrate. • Drive straight forward. • Drive between 4 mph (6 km/h) and 24 mph (39 km/h). System Operation The following warnings or difficulties may occur during feature operation. Tips to resolve them are listed below.

either too far below or too close to the camera to properly recognize the sticker. In order for the system to operate correctly the sticker height must be lowered if you receive the minimum warning or the sticker height must be raised if you receive the maximum warning. • Only one sticker can be placed on the trailer for correct system function. The previous sticker must be removed or covered so only one sticker is visible to the camera. • Measurement B and Cmust be measured again if a new sticker is placed on the trailer. Measurement D has reached maximum or minimum value: • Make sure that the measurement being made is the horizontal distance only from the bumper to the center of the single axle or the center of all the axles on the trailer. See step 4 of the setup for additional measurement instructions. The TBA system does not support trailer lengths outside the range allowed by the information display.

System is circling something beside the sticker or system cannot find the sticker: • Make sure the rear camera is clean and the sticker is clearly visible in the camera image. Clean the camera and sticker if necessary. • The camera system uses the entered measurements to help locate the sticker. Inaccurate sticker measurements will degrade the system’s ability to locate the sticker. Verify the measurements entered into the system are accurate. • Remove the incorrectly circled label or decal if possible. • If you cannot resolve the issue a new sticker location should be tried. The sticker location must still meet the requirements noted in step 3 of the setup instructions. Only one sticker can be placed on the trailer for correct system function. The previous sticker must be removed or covered so only one sticker is visible to the camera.

306

Navigator (TB9) Canada/United States of America, enUSA, Edition date: 201708, First Printing