2018-Navigator-Owners-Manual

Doors and Locks

Anti-Scan Feature The keypad goes into an anti-scan mode if you enter the wrong code seven times. This mode turns off the keypad for one minute and the keypad lamp flashes. The anti-scan feature turns off after: • One minute of keypad inactivity. • Pressing the unlock button on the remote control. • Switching the ignition on. Locking and Unlocking To Unlock All Doors Enter the factory-set 5-digit code or your personal code to unlock all doors. To Lock All Doors Press and hold 7·8 and 9·0 at the same time with the driver door closed to lock all doors. You do not need to enter the keypad code first.

To Unlock the Liftgate Glass Enter the factory-set 5-digit code or your personal code, then press 5·6 to unlock the liftgate glass. Displaying the Factory-Set Code Note: Two programmed intelligent access keys are required for this procedure. 1. Open the floor console storage compartment lid. 2. With the buttons facing the rear of your vehicle and the key ring facing upward, place the first intelligent access key into the backup slot inside the center console. 3. Press the push button ignition switch once and wait for a few seconds. 4. Press the push button ignition switch again and remove the intelligent access key from the center console. 5. Insert the second programmed key into the backup slot in the center console, then press the push button ignition switch.

The factory-set code appears in the information display for a few seconds. Note: The code may not display until after any other warning messages first display.

80

Navigator (TB9) Canada/United States of America, enUSA, Edition date: 201708, First Printing