GRAVITY PLUS 2 Belt

EN CAREFULLY READ THE INSTRUCTIONS BEFORE USING THE FULL BODY HARNESS DESCRIPTION Full body harnesses are Personal Protective Equipment (PPE against falls from a height and are in conformity to the Norm EN 361:2002. The full body harness is a basic component of the fall arrest system in conformity to the Norm EN 363:2018. Some full body harnesses are equipped with work positioning belts (EN 358:2018 and can also include a seat harness (EN 813:2008) intended for use along with positioning and restraint systems. The full body harnesses IRUDEK are in conformity with the European PPE Regulation EU 2016/425. The declaration of conformity is available at the following internet address: http://www.irudek.com/es-es/descargas/ APPLICATION The use of the harness with a fall arrest subsystem must be compatible with the instructions for use of each component of the system and with the Standards: EN 353-1:2014 +A1:2017, EN 353-2:2002, EN 355:2002, EN 360:2002, EN 362:2004. FITTING: Use a harness of appropriate size. A harness with straps that are too loose or too tight may restrict the user's movement and will not provide an optimum level of protection. Fall arrest harness ( EN 361: 2002 ) Step 1: Hold the harness by the dorsal anchorage ring. Step 2: Pass the arms through the shoulder straps and close the plastic buckle of the chest strap. Step 3: Pull the thigh straps one by one around the thighs towards the front. Step 4: Close the buckles of the thigh straps one by one. Step 5: Tighten the straps by pulling the ends of the straps until the sling fits snugly against the body. Step 6: Use the dorsal anchorage ring or front anchorage ring or the textile front ends connected by a carabiner as an anchorage point to a fall arrest system. To locate the anchorage points on the harness, check that a label with an "A" marking is located near the anchorage point. Positioning belt ( EN358: 2018 ) Step 7: Position the belt around the hip, with the padded back support and anchor rings D on each side. Pull one end of the belt until it conforms to the body without impeding free movement and close the buckles. The belt is padded and has two side anchorage rings, which are used as anchorage points for positioning at work. The comfortable back support provides excellent ergonomic support for the back. The belt is adjustable so that the strap can slide freely over the padded back support, making it easy to adjust to the size of the