Complete 2014 Catalog

40 THE CARVER'S CHOICE THE CARVER’S CHOICE

Now you can carve the fixed-point method, or with a flexible-shaft— either way with the same unit. Plus, you have a unique coolant/shield set- up that protects you from any coolant splash, but with no shields to interfere with a clear line of sight to the work piece as you carve. The design of our unique shield and coolant sys- tem makes this possible. Your line of sight passes over one adjustable clear plastic shield and under the other, leaving you with an unobstructed view as you work, yet protected from any splash and splat- ter. You control the coolant flow as well, allowing you to adjust the drip to an efficient minimum. Not only that, you have plenty of room to maneu- ver your work piece around the fixed-point arbor. The chuck accommodates accessory shanks from 0- 5 ⁄ 32 " . The motor is 1 ⁄ 6 HP with adjustable speeds form 500-7000 RPM and comes in either 115 Volt or in 230 Volt for use outside the USA. The Carver's Choice easily converts to allow flex- ible-shaft carving. Just remove the arbor chuck (included with the unit) and attach a flexible-shaft- which must have a 5 ⁄ 16 " coupling. The Flexade ® sold below allows you to use almost any of Foredoms's handpieces (sold on page 27). We do not include a flexible-shaft with the unit. When you convert to the flexible-shaft method, you can move the Work Station unit out away from the motor, giving you plenty of room for movement of the flexible-shaft. The Work Station is com- pletely self-contained, and can be used elsewhere in your shop. Work Station comes with handy flex-lamp, and coolant tank with adjustable valve. The Carver's Choice unit is the suggestion of master carver Dick Friesen, so it works.

FLEXADE ® FLEX-SHAFT Convert your lathe, drill press or electric drill into a flex-shaft machine. For best performance, motor speed should operate at 3500 RPM or higher, and ONLY in a forward direction. Any Foredom Quick Change Handpiece can be attached. The 30" Flexade ® comes with motor coupling. For current models of Fore- dom's M.BL Lathe and other motors with 5 ⁄ 16 " diameter shafts. 103-BO-15...................... 5 ⁄ 16 " shaft............. Shp wt. 1 lb.....................35.00 For Multi-Flex Flex Shaft Carver, older Foredom lathes and other motors with 1 ⁄ 4 " motor shafts. 103-BO-14...................... 1 ⁄ 4 " shaft............. Shp wt. 1 lb.....................35.00 THE CARVER'S CHOICE includes motor, Foredom bench lathe mounted on 11  1 ⁄ 2 " x 14" baseboard, 5 ⁄ 16 " shaft chuck arbor for fixed point carving, complete Carver's Work Station (including lamp). NOTE: Flex shaft is NOT included. 660-CC........ 115 Volt.....Shp wt 27 lbs......................... 444.00 660-CC-X.... 230 Volt.....Shp wt 27 lbs......................... 467.00

FLEXADE ® Flex-Shaft

HANDPIECE AND LATHE SHOWN NOT INCLUDED.