Complete 2014 Catalog

SLAB/TRIM SAWS

47

MODEL TC-10 10 ″ SLAB/TRIM SAW This 10" saw makes it easy to trim and slab small rocks. A power feed mechanism makes slabbing especially easy.

For slabbing, secure your rock in the vise, push the button, and the power feed goes from there. You can slab rocks up to approximately 3  5 ⁄ 8 " x 6" wide by 6" long. The vise glides smoothly and accurately on two stainless steel rails. Vice cross feed is 2". The power feed has an automatic shut-off switch for safety. Trimming slabs is also easy. The arbor is centered on the table so that you can get a 90º perpendicular cut every time. The stainless steel 5 ⁄ 8 " arbor shaft has two sealed ball bearings and extra neoprene seal at the tank for extra long life. The saw table is 13" x 17" with a rim around the edge to contain water and sludge while sawing. The TC-10 comes with a clear, plastic hood that is easily installed and removed. Splash from the cutting blade is contained within, but you can easily check your progress through the clear hood. Clean up is easy, too. The table with vise and switches is hinged at one end, and flips up for access to the cool- ant tank and sludge removal. There is also a drain at one end of the tank.

MODELTC-10 SLAB/TRIMSAWComes with 1 ⁄ 3 Hp 115V/60Hz motor, power feed, vise, and see-through hood. (Blade not included.) 600-10-2500. ......... Shp Wt. 66 lbs..............1615.00 EXPORT MODEL TC-10X Same as above but with 220V 50 Hz motor. 600-10-2500X. ...... Shp Wt. 66 lbs..............1765.00 Tank and table is durable aluminum construction with impact resistant finish for long life. Mounted on a 16" x 24" laminated baseboard. This saw requires oil as a coolant. Tank capacity is approximately one gallon. We recommend Roc-oil. See page 58. NOTE: This saw takes a 10" blade with 5 ⁄ 8 " arbor hole. To order a blade, see pages 55 to 57. See page 45 for spare parts or call our Customer Service for more information.

See page 103 for goggles. (Included with all Diamond Pacific trim saws)

The Model TC-10 10" saw is attached to a 16" x 24" laminated base- board. Overall length of the saw is approximately 30" to include motor and power feed controls.