Newton McDonald-2017

Testing Customer-Owned Equipment

3. Strip cable jacket back 1-3/4 inches. Remove 3/8 inch of insulation from individual wires. Pass wire between legs of hinge. 4. Loosen four screws – DO NOT REMOVE. Match wire to color coded screws. Loop wire clock- wise between washers. Tighten screws securely. ALTERNATE WIRE COLORS: Blue/White to Red Blue to Green Orange to Yellow Orange/White to Black 5. Route wires neatly. Close net- work interface cover; press until cover clicks closed. Testing: Open cover and plug a working telephone into jack. Normal opera- tion shows telephone line is work- ing properly. If phone does not operate, close cover and notify repair service. Customer Lock: A #10 Master padlock, or equivalent, may be installed on the network interface for security.

Caution: To avoid electrical shock hazard when servicing telephone wiring, open cover of network inter- face to break electrical connection to wiring. Terminal Access: Locate proper network interface and open cover by depressing latch as shown. Open cover fully. Wiring: 1. Use a sharp pencil to puncture a small hole through the center of the grommet located in the bottom right of the housing. 2. Pull wire through hole in grommet. Route wire to proper network interface.

Lock Hasp

Cover Latch

Test Jack

T

OPEN

R

Colored Screws

10