2018 Edge Owner Manual

Wheels and Tires

gauge reading will indicate the tire inflation pressure after about 30 seconds of operation. You should check the final tire pressure with the compressor turned OFF in order to get an accurate pressure reading.

5. Remove the warning sticker found on the casing/housing and place it on the top of the instrument panel or the center of the dash. 6. Start the vehicle and leave the engine running so the compressor does not drain the vehicle’s battery.

E175982 9. When the tire reaches the

E175981 7. Turn dial (A) clockwise to the sealant position. Switch the kit on by pressing the on/off button (B). 8. Inflate the tire to the pressure listed on the tire label located on the driver's door or the door jamb area. The initial air pressure gauge readingmay indicate a value higher than the label pressure while you pump the sealing compound into the tire. This is normal and should be no reason for concern. The pressure

recommended tire pressure, switch off the kit, unplug the power cable, and disconnect the hose fromthe tire valve. Re-install the valve cap on the tire valve and return the kit to the stowage area. 10. Immediately and cautiously, drive the vehicle 4 mi (6 km) to distribute the sealant evenly inside the tire. Do not exceed 50 mph (80 km/h). After 4mi (6 km), stop and check the tire pressure. See Second Stage: Checking Tire Pressure. 11.

302

Edge(CDQ)Canada/UnitedStatesofAmerica,enUSA,Editiondate:201706,FirstPrinting