TPT May 2014

Technology News

Hydroforming press increases throughput and reduces cycle time INTERLAKEN Technology, a

The multi-channel closed loop control system is easily programmed to handle various sizes and materials. It also offers dynamic mode switching, which enables the user to switch between a variety of feedbacks such as force, position, internal pressure and other system variables. For over 34 years, Interlaken Technology Corporation has been designing and manufacturing servo- controlled equipment with sophisticated controls and monitoring software. This experience and knowledge allows the company to provide solutions for production press equipment. Interlaken offers an extensive warranty, and service and technical support.

systems, has introduced a new four- column hydroforming press system for running high-volume production while reducing cycle time. The new

manufacturer of production press equipment for hydroforming, elevated temperature forming, and hot stamping

hydroforming press system is offered in clamp forces from 250 to 5,000 tons. Hydroformed parts are stronger and weigh less due to structural integrity and fewer welds or add-on pieces. In addition, costs are reduced and time is saved by eliminating secondary operations, reducing scrap, lowering material and manufacturing costs, and increasing design flexibility. With superior control over forces and motions, Interlaken’s hydroforming press is claimed to provide a greater overall quality of formed parts.

Interlaken Technology – USA Fax: +1 952 856 4221 Email: dprill@interlaken.com Website: www.interlaken.com

Interlaken’s new high-volume production hydroforming press system

SIDE LOADING FOR FAST TOOL CHANGE AND NO LIFTING REQUIRED • Infinitely adjustable expansion & reduction • High production capability TUBE END FORMING AV65

50 Years latest technology for highest precision.

Our new innovation: tube Extreme | cut CUTTING SOLUTION IN PERFECTION

NEW

• Up to Ø 152mm • No tube clamping required • End form on or near bends • High quality build with practical platforms • Full 12 month warranty. • Twin Head Machines also available

tube

cut Extreme

SPECIALS

ADVANTAGES

• A clean cut • Improved material utilization

• Very small tooth pitch possible • Thinner than conventional cold sawing blades • Optimized tooth geometry • Wear-resistant coating AKE Knebel GmbH & Co. KG Hölzlestrasse 14 + 16 72336 Balingen Germany

• Higher feed rates • Shorter cycle time

Unit 24, Padgets Lane, South Moons Moat, Redditch, Worcestershire B98 0RB, England. T: +44 (0)1527 518520 E: info@avamatic.co.uk W: www.avamatic.co.uk Germany: Tel: 02150 2500 Netherlands/Belgium: Tel: (04756) 6888 USA: Tel: 708 272 7880

Phone +49 (0) 7433 | 261- 0 Fax +49 (0) 7433 | 261-100 Mail info@ake.de

54

www.read-tpt.com

M ay 2014