2018 Mustang Owner's Manual

Convertible Top (If Equipped)

Using the Tonneau Caps Your convertible top also includes two tonneau caps, one for each side of the vehicle. These caps stow inside the trunk.

To remove the tonneau caps: 1. Slide B toward the center of the vehicle to release the edges from the surrounding trim. 2. Lift up on B, and then pull the piece back to release tab A from the trim. 3. Repeat Steps 1 and 2 on the opposite side of the vehicle. 4. Make sure you stow both pieces in the trunk.

E205441

A.

Leading edge.

Side edge. B. After opening your convertible top, place the tonneau caps between the top and your vehicle trimmoulding: 1. Insert tab A under the trim. 2. When tabA is under the trimslot, angle B down so the edges slide under the surrounding moulding and secure into place between the trim edges. 3. Repeat Steps 1 and 2 on the opposite side of the vehicle to install the second tonneau cap. CLOSING THE CONVERTIBLE TOP Closing the convertible top is a three-step process: Remove both of the tonneau caps, press the convertible top control to close the top, and then close the latch.

E179941 Note: The convertible top does not operate unless the vehicle is stationary or traveling under 3mph (5 km/h). A chime sounds and a warning message appears in the instrument panel.When you slowdown, the top operates. Note: You must remove the tonneau caps before you are able to close the top or a chime sounds and a warning message appears in the instrument panel. Remove and stow the caps in the trunk, and then press the convertible top control again. Note: When you latch or unlatch the convertible top, the audio systemmutes briefly. This allows the vehicle to optimize the cabin’s sound quality depending on the position of the convertible top.

197

Mustang(CZG)Canada/UnitedStatesofAmerica,VehiclesBuiltFrom:07-08-2017, JR3J 19A321AAenUSA,Editiondate:201707,FirstPrinting