neocube Operating and installation instructions - models P/C

Maintenance The wood-burning stove should undergo a thorough inspection at least every two years. The inspection includes: • Thorough cleaning of the wood-burning stove. • Checking the gaskets and replacing them if damaged or no longer soft. • Checking the firebrick lining in the combustion compartment. • Checking the design type (only in certain countries). • Checking the bottom of the combustion compartment. • Hinges and locking hooks must be lubricated with copper grease (heat-resistant up to 1100°C)..

Maintenance must be carried out by a qualified installer. Only use original replacement parts.

12. Operational disruptions

Sooty glass • Wood is too damp. Only use wood that has been stored under cover for a minimum of twelve months with a moisture content of approx. 18%. • The door gasket may not be properly sealed.. Formation of smoke when opening the front door • The throttle valve in the chimney may be shut. Open the throttle valve. • No draft in the chimney. See the section describing the chimney or contact your local chimney sweep. • The cleaning door is not properly sealed or has fallen out. Replace or re-install. • Never open the door when there are flames. It is not possible to regulate the heating • The door or ash pan gasket is not properly sealed. Replace the gasket. • If the draft is too strong in the chimney, the regulating rod may need to be closed. If the stove is not in operation, close the regulating rod. • If the steel panels are burnt or deformed, the stove is not heating correctly. Stop using the stove and contact your specialist.

Poor draft in the stove • Is the chimney too low or the cross-section unsuitable? • Is the chimney or the flue pipe not properly sealed? • Is the door open on another stove leading to the same chimney? Difficult to make the fire in the wood-burning stove • Is the room too big for the stove? • Is the ash pan full? • Is the smoke outlet blocked? • Are the combustion air controls closed? • Is the stove connection to the chimney properly sealed? Stove emits too much heat • Are the combustion air controls fully open? • Is the stove door closed correctly? • Is the ash pan fully closed? • Is there too much fuel?

In the event of operational disruptions that you are not able to resolve yourself, please contact the place of purchase.

neocube P / C – Operating and installation instructions

37