Page 73 - Alpha Tech Pet, Inc. - Distributor Support Binder (April 2013)
Basic HTML Version
Approved. Proven. Powerful.
1-800-808-1723
lotus
®
PRO Technical Bulletin
High Capacity Unit Front Label
FLOW
OFF
ON
System Ready
System Charging
Replace Stabilizer
Change Sensor
SERVICE
TO OPERATE:
1. To start Press FLOW to ON.
2. Dispense when SYSTEM READY is GREEN.
3. Press FLOW to OFF when not dispensing.
This is a guide to help understand the High Capacity Unit label
and what the lights mean.
1) System Ready
You are producing AO and ready to fill your mop buckets,
sprayers, or other applicators.
2) System Charging
Within 15 seconds of turning the Flow into the on position you
will see the “System Charging” light come on at the front of the
HCU and switch to Green “System Ready”
3) Change Sensor
Will light when the HCU is not producing Ozone - this could
mean one of the following:
• Low water pressure – must be between 35-60psi.
• Hot water is connected or turned on instead of COLD water.
If you have the correct PSI and are using cold water try the
following troubleshooting:
• Continue to run the unit for a longer period of time 1 to 2
minutes to see if the light will clear.
• Is the high capacity plugged in using an extension cord. Is
it commercial grade? If not insert direct to power or use a
commercial grade extension cord.
• Ensure other items plugged into the same outlet are
removed and test the unit alone on the outlet.
4) Replace Stabilizer
Flashing orange light: filter and stabilization module needs
replacement in 50 gallons.
Solid orange light: filter and stabilization module needs
replacement immediately.
5) Service
If get a red light, check that the cold water is turned on. Check
that there are no kinks in the line to allow uninterrupted flow
of water. Also check that the cartridge is in properly and the
protective plastic on the cartridge has been removed.
If you still encounter issues please contact lotus
®
PRO customer
care
or 1-800-808-1723 EXT 530.
