Flat 3 Cremer Street Home User Guide

Fault, what to do?

en

Fault table

Fault

Cause

Remedial action

“Check water supply” display )2 lights up.

Supply hose kinked.

Install supply hose without kinks.

Tap turned off.

Turn the tap on.

Tap jammed or calcified. Turn the tap on. Flow rate must be min. 10 l/min. when water supply is open. Filter in the water supply blocked. Switch off the appliance and pull out the mains plug. Turn off the tap. Unscrew water connection.

Clean filter in the supply hose. Screw water connection on again. Check for leaks. Reconnect power supply. Switch on the appliance. Clean filters. (see “Cleaning and maintenance”). Install hose without kinks, remove any residue. Check connection to siphon and open if required. Switch off appliances with the ON/OFF switch ( . After a short time restart the appliance. If the problem recurs, turn off the tap, pull out the mains plug and call customer service. Clean appliance with dishwasher cleaning agent or descaler. Operate the dishwasher with water softening system and check the setting (see chapter “Water softening system/Special salt”). Lock cover correctly. (See “Waste water pump”)

Filters 1R are soiled or blocked. Waste-water hose kinked or blocked.

Siphon connection still sealed.

Waste water pump blocked or cover on the waste water pump is not locked in position. A technical fault has probably occurred.

Display “Check water supply” )2 flashes.

Refill indicator for salt )* flashes.

Heating element calcified or soiled.

29