Reece 32

AUTOMATIC PATCH LOADING

Automatic Patch lot.Jding is electrically controlled and operated. With Control Panel Switches set for the desired operating procedure c.rnd with Patch Tray loaded with Welting and Backing N\aterial, pressing the Pedal wil I start the following· automatic sequence: Clamp wi II lower on Stay and Work Material. Clamp Table will travel to its rear position. Automatic Patch Loader wil I load Welting and Backing Material into position.

Patch Folders wi 11 fold Welting and Backing Material around Patch Guide. Patch Tray will return to its rest position. Sewing and Center Cutting will be completed. Patches wil I be turned and Tabs cut. Upon completion of the Sewing and Turning, the Clamp wi 11 rise and the Work is removed.

CONTROL CIRCUIT BOARD

CIRCUIT SWITCHES

WELTING & BACKING MATERIAL

PEDAL

RELAY

AUTOMATIC PATCH LOADING CIRCUIT

MAINTENANCE AND ADJUSTMENTS

PATCH LOADER AND STOP _For proper Loading and Folding of the Welting and Backing Patches, the following conditions must be met: 1. Smooth and uninterrupted movement of the Patch Loader Arm. 2. The Arm should not be deflected or bind. as it contacts the Stop. 3. Sides of the Patch Tray should be parallel with the sides of the Patch Guide. 4. A 1/2 11 clearance between the Needles and the inside edge of Back Block when Patch Tray is in loading position. 5. Patch Guide must be centered in the opening of the patch tray.

In order to make these adjustments, the A4tomatic Patch Loader shou Id be set to operate manua II y.

Set the Control Panel Switches as follows: Main ............ Pull to Start Selector ......... p & E Clamp Safety ••••• Rep. Loading •••••••••• Man. Front Loader Sew •• ; •••• Off

Ciamp Clearing ••• Center Fingers ••••••••••• Semi

From the Library of Superior Sewing Machine & Supply LLC