IRUDEK EPXERT PRO 300 HARNESS

-A fall arrest harness is the only acceptable body restraint device that can be used in a fall arrest system. -The fall protection system must only be connected to harness connection points that are identified with a capital "A". L The identification "A/2" indicates that two connection points with the same identification must be connected at the same time. It is forbidden to connect the protection system to a single connection point which is marked "A/2". In harnesses with a built-in belt, the connection to the work positioning equipment must be made only to the side anchorage rings of the belt. -Connection to the anchorage point and to other equipment must be made via carabiners in accordance with EN 362:2004. -For use with fall arresters EN 353-1:2014+A1:2017, EN 353-2:2002 it is recommended to connect the equipment to the harness front anchorage point. For use with energy absorbers EN 355:2002 or fall arresters EN 360:2002 it is recommended to connect the equipment to the dorsal anchorage point of the harness. -Before each use of the personal protective equipment, it must be carefully checked to ensure that it is fit for use and functioning correctly. During the pre-use check, all parts of the equipment must be carefully inspected for signs of deterioration, excessive wear, corrosion, abrasions, UV degradation, cuts and incorrect use. Special attention should be paid to straps, seams, anchorage rings, buckles and adjustment elements. INFORMATION AND RECOMMENDATIONS -Before use, establish a rescue plan to be able to carry it out in case of emergency. -Do not make any alterations or additions to the equipment without the prior written consent of the manufacturer. -Equipment must not be used outside its limitations, or for other than its intended purpose. -Ensure compatibility of equipment items when assembled into a system. Ensure that all items are compatible with each other and appropriate for the proposed application. It is prohibited to use the protection system where the operation of an individual item is affected by or interferes with the function of another. Periodically check connections and fittings of components to prevent accidental disconnection or loosening. -If damage is detected or if there is any doubt as to its suitability for safe use, the personal protective equipment must be removed from use immediately. In the event of deterioration or any doubt as to its condition for safe use, personal protective equipment must be removed from use immediately. It must not be used again until a competent person confirms in writing that it is acceptable to do so. -In the event that a fall has stopped, the equipment must be removed from use. -It is essential for safety to check the minimum clearance required below the user's feet in the workplace before each use, so that in the event of a fall there is no collision with the ground or other obstacle in the path of the fall. Details of the required minimum clearance can be found in the instructions for use of the respective components of the fall arrest system. -During use of the equipment it is necessary to pay particular attention to dangerous circumstances which may affect the behaviour of the equipment and the safety of the user, and in particular: