EoW March 2012

wire 2012 show

26 - 30 March

➣➢➣ Drawing has already proved its value for comparably simple cold-form parts. An additional advantage is that stock-keeping of wire rods is not complicated at all. Costs for accommodation are cut in half. Wire rods can be stocked on top of each other while nished drawn wire needs to be stocked with much more care. For wire rods, a simple roo ng construction is su cient, as a little ash rust does not have any negative in uence on the production process. Any remnants of wire, which are a signi cant part of the total costs, can be used for future orders. Even short-notice changes of diameter tolerances can be adhered to using the same initial wire rod. With the procurement of a new drawing die within a few days, production simply continues. With the increase of tonnage used – for example from one ton to two tons of wire – change over time at the press can be cut in half. In this context, it is often argued that the tooling time of the wire drawing machine has also to be taken into consideration when calculating cost e ectiveness. Tooling time for changing of rings is between 5 and 15 minutes per change. But considering that there always is a bu er of 5 to 10 wire windings on the drawing disk, a new coil of wire can easily be put onto the wire plate, while these bu ers are being used up. In doing so, tooling times are cut in two. The pointing of wire also can take place apart from the production line. Jankowski GmbH & Co KG – Germany Fax : +49 268 792 7320

Email : postbox@jakoki.de Website : www.jakoki.de

Jouhsen-Bündgens Stand: 11G61

Jouhsen-Bündgens will present its latest machine for end working. This new machine does the job of lathes (chamfer, round end) but much faster and with increased precision. Because of the high-end design the machining can be done with 300 to 400 parts/min and a very high precision is reached by xing the parts in a transport plate in front of the machining station. The machine covers a diameter range from 1 to 3mm and lengths from 15 to 30mm in straightening, cutting and chamfering.

Increased precision

▲

The company will also display a new straightening and cutting machine, MJC 3, for wire diameters 0.5mm to 3mm, as well as a new high speed straightening and cutting machine driven by servo motors for ne wire up to 1.5mm (MJCE), both running up to 800 parts per minute. Jouhsen-Bündgens Maschinenbau GmbH – Germany

Fax : +49 240 210 206 790 Email : info@jouhsen.de Website : www.jouhsen.de

130

EuroWire – March 2012