Lincoln-MKZ-Owner-Manual

Maintenance

Adjusting Automatic Transmission Fluid Levels

Note: An overfill condition of transmission fluid may cause shift or engagement concerns or possible damage. Do not use supplemental transmission fluid additives, treatments or cleaning agents. The use of these materials may affect transmission operation and result in damage to internal transmission components. Reinstall the air filter assembly. After the fluid level has been checked and adjusted as necessary, do the following: 1. Shut the engine off. 2. Loosen the clamp holding the air filter assembly to the rubber hose. 3. Rotate the air filter assembly 90 degrees clockwise without disconnecting the sensor. 4. Seat the air filter assembly back into the grommets by pushing down on the air filter assembly. 5. Tighten the clamp. 6. Install and tighten two bolts that attach air filter assembly to the front of the vehicle. 7. Install the bolt cover (if equipped).

8. Reinstall the harness retaining clip into the front of the air filter assembly.

BRAKE FLUID CHECK

WARNINGS Do not use any fluid other than the recommended brake fluid as this will reduce brake efficiency. Use of incorrect fluid could result in the loss of vehicle control, serious personal injury or death. water, petroleum products or other materials may result in brake system damage or failure. Failure to adhere to this warning could result in the loss of vehicle control, serious personal injury or death. Do not allow the fluid to touch your skin or eyes. If this happens, rinse the affected areas immediately with plenty of water and contact your physician. Only use brake fluid from a sealed container. Contamination with dirt,

E158845

E158846

Before adding any fluid, make sure the correct type is used. The type of fluid used is normally indicated on the dipstick and also in the Technical Specifications section in this chapter.

318

MKZ (CC9) Canada/United States of America, enUSA, Edition date: 201706, First Printing