CADDManual_2016-FINAL.pub
BL Companies // File Management & CADD Standards Manual
> > > TUTORIALS < < <
+ BEST PRACTICES & TUTORIALS (CONT.)
→ Dimensioning
The Dos and Don'ts for plan dimensioning….
Trying to dimension from an inaccessible point? Don’t know the actual versus nominal widths of the wall?
Interior Dimensioning Dos:
Interior Dimensioning Dont's:
Each wall/ element must be located.
Don't Dim. to face of finishes.
Dim. what the contractor needs, noting more, nothing less.
Don't Dim. to a column line referencing a re- mote column.
Dim. from a column line within reasonable distance column should be in the same space, not across the building.
Don't over Dimension.
Always dim. to face of stud. conc or masonry.
Don't Dim. to/from opposing sides of a wall (understand actual vs. nominal widths).
When dim. frames, dim. to outside of frame
Don't Dim. from an inaccessible point.
Dim. to/from the same side (correct side) of a wall. Know your actual vs. nominal widths: 3-5/8" studs, 7-5/8" CMU
Section 2 // Page 36 < < <
Made with FlippingBook