MVF / MVP - Erection Manual

MVF/MVP M echanically S eamed V ertical Leg F lat M echanically S eamed V ertical Leg P encil-rib

®

SPECIAL ERECTION TECHNIQUES

MID-SLOPE FIXED CONDITION LOW EAVE

FLOATING HIGH EAVE PLATE

Refer to erection drawing General Details for expansion joint installation instructions if required.

EQ. EQ.

HIGH SYSTEM

*1/4"-14 X 1 1/4" WT (4) PER PANEL (Maintain 1 1/2" minimum from face of special trim to panel screw.) (2)1/4"-14 X 7/8" WT

SEE ERECTION DRAWINGS SEE ERECTION DRAWINGS

"PIG-TAIL" TAPE MASTIC

MVF/MVP ROOF PANEL

TAPE MASTIC

GUTTER STRAP (GSM) (2'-8" C.C. AT PANEL HI-RIBS)

#12-14 X 1 1/4"

*

FLOATING LOW EAVE PLATE

GUTTER (EGM)

(2)1/4"-14 X 1 1/4" SHOULDER FASTENERS THROUGH CENTER OF EACH SLOT

1/4"-14 X 7/8" WT (6" C.C.)

DOUBLE BEAD TAPE MASTIC

1/4"-14 X 7/8" (12" C.C.)

#12-14 X 1 1/4" (6" C.C. for CS PANEL) (12" C.C. for AP PANEL) EAVE STRUT

TRIM CAP

LOW SYSTEM

NOTES 1. The special details for use when a panel run exceeds the thermal movement capabilities of the panel clip. 2. A positive panel attachment is made at the mid-point in the panel run allowing for thermal movement at the eave and ridge. 3. The standard floating ridge condition must be used in conjunction with this special eave detail. 4. The floating eave plate must be used to allow for panel movement at the eave. 5. Sliding clips have a maximum movement of 1" in each direction. Thermal calculations must be preformed for each project to ensure that the thermal movement of the roof will not exceed the design of the clips and slot in the special eave plate.

MVF/MVP-58

Version 2.0

SUBJECT TO CHANGE WITHOUT NOTICE