2018-Flex-Owner's-Manual

Roadside Emergencies

Jump Starting 1. Start the engine of the booster vehicle and rev the enginemoderately, or press the accelerator gently to keep your engine speedbetween2000and3000 RPM, as shown in your tachometer. 2. Start the engine of the disabled vehicle. 3. Once the disabled vehicle has been started, run both vehicle engines for an additional three minutes before disconnecting the jumper cables. Removing the Jumper Cables Remove the jumper cables in the reverse order that they were connected.

Note: In the illustration, the bottom vehicle represents the booster vehicle.

1

3

4

2

4

E142664 1. Connect the positive (+) jumper cable to the positive (+) terminal of the discharged battery. 2. Connect the other end of the positive (+) cable to the positive (+) terminal of the booster vehicle battery. 3. Connect the negative (-) cable to the negative (-) terminal of the booster vehicle battery. 4. Make the final connection of the negative (-) cable to an exposedmetal part of the stalled vehicle's engine, away from the battery and the fuel injection system, or connect the negative (-) cable to a ground connection point if available.

1

2

3

E142665 1. Remove the negative (-) jumper cable from the disabled vehicle.

222

Flex(TP3) ,enUSA,Editiondate:201704,FirstPrinting