2018-Flex-Owner's-Manual

Maintenance

Correct Fluid Level If the fluid level is within the hash mark area (between points A and B) do not add any fluid. High Fluid Level If the fluid level is above the maximum range (above point B) fluid may need to be removed. High fluid levels may be caused by a overheating condition. If you have operated your vehicle at high speeds, towing a trailer or in city traffic during hot weather, allow your vehicle to cool for a minimumof 30minutes before rechecking the level. Note: An overfill condition can damage the transmission. Adding Transmission Fluid * 1. Rotate the automatic transmission fluid cap in a counterclockwise direction. 2. Remove the cap and dipstick andwipe it with a clean, lint-free cloth. 3. Add fluid that meets the Ford specifications. See Capacities and Specifications (page 305). Pour the fluid directly into the automatic transmission fluid cap and dipstick hole. 4. Replace the cap and dipstick and remove it again to check the fluid level. 5. Make sure that the fluid level is between the MIN and the MAX marks. 6. Replace the automatic transmission fluid cap anddipstick. Turn it clockwise until you feel a strong resistance. * VehiclesWith EcoBoost Engine WARNING Do not run the engine with the air filter disconnected.

1. Loosen the clamp holding the air filter assembly to the rubber hose. 2. Remove the air filter assembly securing bolts. 3. Lift the air filter assembly to disengage the locating pins. 4. Rotate the air filter assembly slightly in a counterclockwise direction. 5. Check the transmission fluid level. 6. Install the air filter assembly in reverse order. Tighten the air filter assembly securing bolts until you feel a strong resistance. Do not use any fluid other than the recommendedbrake fluidas thiswill reduce brake efficiency. Use of incorrect fluid could result in the loss of vehicle control, serious personal injury or death. Only use brake fluid from a sealed container. Contamination with dirt, water, petroleum products or other materials may result in brake system damage or failure. Failure to adhere to this warning could result in the loss of vehicle control, serious personal injury or death. Do not allow the fluid to touch your skin or eyes. If this happens, rinse the affected areas immediately with plenty of water and contact your physician. A fluid level between the MAX and MIN lines is within the normal operating range and there is no need to add fluid. A fluid level not in the normal operating range could compromise the performance of the system. Have your vehicle checked immediately. BRAKE FLUID CHECK WARNINGS

254

Flex(TP3) ,enUSA,Editiondate:201704,FirstPrinting