2018-Flex-Owner's-Manual

Wipers andWashers

WINDSHIELDWIPERS Note: Fully defrost the windshield before you switch the windshield wipers on. Note: Make sure you switch the windshield wipers off before entering a car wash. Note: If streaks or smears appear on the windshield, clean the windshield and the wiper blades. If that does not resolve the issue, install new wiper blades. Note: Do not operate the wipers on a dry windshield. This may scratch the glass, damage thewiper blades or cause thewiper motor to burn out. Always use the windshield washers before wiping a dry windshield. E208496 • Rotate away from you for long wipe interval. • Rotate toward you for short wipe interval. Speed Dependent Wipers When your vehicle speed increases, the interval between wipes decreases. AUTOWIPERS (If Equipped) Note: Fully defrost the windshield before you switch the windshield wipers on. Note: Make sure you switch the windshield wipers off before entering a car wash.

Note: If streaks or smears appear on the windshield, clean the windshield and the wiper blades. If that does not resolve the issue, install new wiper blades. Note: If you switch autolamps and autowipers on, the headlamps turn onwhen thewindshieldwipers continuously operate. Wet or winter driving conditions with ice, snow or salty road mist can cause inconsistent and unexpected wiping or smearing.

E256816 Use the rotary control to adjust the sensitivity of the autowipers. When you select low sensitivity, the wipers operate when the sensor detects a large amount of water on the windshield. When you select high sensitivity, the wipers operate when the sensor detects a small amount of water on the windshield. Keep the outside of the windshield clean. The rain sensor is very sensitive and the wipers may operate if dirt, mist or insects hit the windshield. In these conditions, you can do the following: • Lower the sensitivity of the autowipers to reduce the amount of smearing on the windshield. • Switch to normal or high-speed wipe. • Switch autowipers off.

80

Flex(TP3) ,enUSA,Editiondate:201704,FirstPrinting