004722_Superior Die Sets

Three typically used boss and heel block wear plate systems (U,L,V) are available from Superior. Wear plates are uniquely positioned to offset die forces and help to maintain die life even though the press-ram may be poorly aligned. The V system is often used on standard pin and bushing type die sets where extra rigidity is needed at an economical choice. The V blocks, with 45° angles, are positioned between the components similar to a thrust block to aid in die alignment. This system is also excellent in retrofitting existing dies by adding the V system where space permits. WEAR PLATE DIE SET - V SYSTEM

VA

VO

VW

VH 2 −

VC

VH

VL

V SYSTEM DIMENSION

VL

VW VO VA VC VH

5 9 / 16

V1

4 ¾

7 ¼

11⅛ 5 ¾ 4 ¾

V2

13

5 ¾

6 ½

7 ¼

4 ¾

4 ¾

Maximum recommended height = 6”

Wear plates are available in hardened steel, solid bronze, or self-lubricating types.

uncontrolled if printed or downloaded

1250