WCA November 2011

Technology news

Measuring technology in insulating and jacketing lines

❍ Possible configurations of Sikora measuring technology in insulating and jacketing lines

During production cable manufacturers can measure the cable length with the help of Length 6000 and ensure that precisely the required length of cable is produced. Continuous quality control during cable production is a precondition for economical production, as risks can be identified and faults can be prevented at an early stage.

of the cable and to minimise material consumption. The application field of the X-Ray 6000 ranges from one or two layer insulations (common in the insulating and jacketing area) to RF cables with foamed Pe-insulations. By using an X-ray 6000 as hot measuring head after the extruder and a diameter measuring head after the cooling trough in combination with a control, a constant diameter can be achieved. With the hot/cold control module HC 2000 the material shrinkage can be calculated and automatically considered for the control of the diameter or wall thickness. Besides the X-ray 6000, which measures the dimensions of the cable, testing and measuring devices are necessary to assure cable quality regarding material properties. Customers can configure their lines with Sikora measuring devices tailored to their needs. The insulation is tested online with a spark tester (high voltage spark tester). As a result possible irregularities in the insulation are detected and documented at an early stage. An implemented quality management system assures that only faultless cables are delivered. For cables for which the decision is made to run without eccentricity control, the conventional method of the average wall thickness measurement, by the diameter differential calculation, is available.

CABLe manufacturers are obligated to fulfil customer specifications at the production of cables. These specifications refer to the dimensions of the cable as well as their material or signal transmission characteristics. In order to meet the demands there are measuring technologies used in the lines that continuously monitor cable quality during production. In insulating and jacketing lines, where for example energy cables or communication cables are produced, the X-ray 6000 helps to permanently comply with the required specifications. the measuring values of the wall thickness, eccentricity, outer diameter and ovality are available at the processor system ecocontrol 6000. The eccentricity measuring values are displayed at eight points and allow the operator an optimal centring of the extrusion tools and controlling of the wall thickness or the diameter to the nominal value. The values are numerically or graphically displayed as cable cross section. The measuring device is, depending on the application, installed between two cooling trough sections or after the cooling trough. It measures the insulation wall thickness of the material layers as well as the position of the conductor in the insulation. The conductor has to be absolutely concentric in the insulation to assure the mechanical and electrical function With online measurement

Sikora AG – Germany Fax : +49 421 48900 90 Email : sales@sikora.net Website : www.sikora.net

clean wire before annealing

candor

can do wire equipment

Electrolytic plating ◆ Candojet hot water cleaning ◆ Electrolytic & Ultrasonic ◆ degreasing Welding wire cleaning and ◆ copper coating Pickling & phosphating ◆

YOUR number one for Asia

CANDOR Sweden AB Tel: +46 11 21 75 00 Email: info@candorsweden.com Fax: +46 11 12 63 12 Website: www.candorsweden.com

43

Wire & Cable ASIA – November/December 2011