Standard_Drives_Guide

AF-650 GP General Purpose Drive Standard Specifications

Operation (continued) Output Signals

Keypad Keypad Features

2 - Digital Outputs 24 Vdc (Digital Outputs are used in place of 2 of the Digital Inputs) 2 - Form C Relays rated to 2A at 240 Vac 1 - Analog Output 0/4 to 20mA Relay Output Settings:

LCD Display with 6 Alpha-numeric lines. Multi-Language Support Hot Pluggable, Remote Mount Option, and CopyCat Feature, IP65 rating when remote mounted on enclosure LED's - Green - drive is on, Yellow - indicates a warning, Red - indicates an alarm, Amber - Indicates active Menu keys and H-O-A keys Status - shows status of drive Quick Menu - Enters Quick Start, Parameter Data Check, or Trending Modes Main Menu - Used for programming all drive parameters Alarm Log - Used to display Alarm list Back - Reverts to previous step or layer in parameter structure Cancel - Used to cancel last change or command Info - Displays information about a command, parameter, or function in any display. Hand/Off/Auto - Used to control drive locally or put drive in remote mode Reset - Used to reset Warnings or Alarms Up to 4 Separate complete parameter set-ups are available Trend Speed, Power, Frequency or any value programmed in status display 2 Level Password Protection

No Operation Control Ready Drive Ready Drive Ready in Remote Standby No Drive Warnings Drive Running Drive Running No Drive Warnings Drive Running on Remote Alarm Alarm or Warning At Torque Limit Out of Current Range

Keypad Keys

Below Current Above Current Out of Speed Range Below Speed Above Speed Out of Feedback Range Below Feedback Above Feedback Thermal Overload Warning

Password

Alternate Motor Parameters

AF-650 GP General Purpose Drive

Graphical Trending

Reverse Bus OK Torque Limit and Stopped Brake and no Warning Brake Ready and No Faults Brake Chopper Fault External Interlock Out of External Reference Range

RS485 Modbus RTU Serial Communications Physical Level: EIA/RS485 Transmission Distance: 1640 ft (500m) Node Address: 32 Transmission Speed:

2400, 4800, 9600, 19200, 38400,or 115200 (bits/s)

Transmission Mode: Transmission Protocol

Half Duplex Modbus RTU

Below External Reference Above External Reference Fieldbus Controlling Drive No Alarm Running in Reverse Local Mode Active Remote Mode Active Start Command Active

Character Code: Character Length:

Binary 8 Bits

Error Check:

CRC

Mounting Clearance

All AF-650 GP drives can be mounted Side-by-Side without spacing. For all drives rated 100HP or below allow 3.4 inches (100mm) free space above and below. For all drives rated 125HP and above allow 8.9 inches (225mm) free space above and below.

Hand Mode Active Auto Mode Active

Protective Functions

Line Phase Loss DC Overvoltage DC Undervoltage Drive Overload Motor Overtemperature Motor Thermistor Overtemperature

Torque Limit Overcurrent Ground Fault Short Circuit Control Word Timeout

Brake Resistor Short-Circuited Brake Chopper Short-Circuited Brake Check

DC Link Voltage High DC Link Voltage Low

Internal Fan Fault External Fan Fault Power Board Overtemperature

Missing U Phase Missing V Phase Missing W Phase Internal Fault Control Voltage Fault

Auto Tune Check - Wrong Motor Parameters Auto Tune Low Inom - Motor current is too low Current Limit Mechanical Brake Low Drive Initialized to Default Value Keypad Error No Motor

Soft Charge Fault Auto Tuning Fault Serial Comms Bus Fault Hardware Mismatch Speed Limit

Standard Drives Buyers Guide

www.geindustrial.com

31

Prices and data subject to change without notice