Westpoort VCA Eindtermen Basis, VOL, VIL VCU Engels

-

Personal protective equipment must be present and used correctly

- - -

Operate correctly

Hazardous zone shielding

Brake to prevent the machine from running for too long

- Presence of instruction card for operation (machines) - Good dust extraction (if applicable) - Fixed machines are equipped with an emergency stop Function (emergency stop) In case of emergency, stop the machine as quickly as possible

General hazards and possible injuries - Being caught by moving parts -

Being struck by flying material/particles

- -

To get stuck Electrocution

- High or low temperature of the workpiece - Hearing damage due to noise - Physical complaints due to vibrations - Physical overload due to incorrect posture - Fault in the control or energy source - Distracting the operator - Cuts or abrasions - Bad maintenance - Dislocation of hand and wrist and bruises due to incorrect use - Fire or explosion due to arcing - Injury due to tool bites - Long running time of machines - Touch cutting parts - Inhaling harmful dust

Requirements (emergency stop) - Easily accessible -

Be clearly visible and recognizable After using the emergency stop, the installation can only restart with the normal start-up procedure

-

Function (no-load switch/no-voltage switch) A no-load switch/no-voltage switch ensures that the machine does not start automatically if the power has disappeared and then returns. Safety measures and requirements (machine operator) - Have sufficient education and experience - 18 years or older (for operating dangerous machines) - Do not wear loose clothing or loose jewellery or hair - Only wear tight-fitting gloves when contact with rotating parts is possible and/or when there is a risk of being caught - Do not bypass, disable or remove security - Do not leave a running machine unattended - Know the location and function of the emergency stop

General demands -

Periodic check-up

-

Validity period with sticker or colour coding

- Have use and maintenance instructions in the language of the country where it is used - Provided with a CE marking after 1995 - Moving parts are shielded - Be in good condition and suitable for the work to be carried out

General safety measures -

Disabled during maintenance work Never run with the drive open

- -

The floor around machines and permanently installed tools must be tidy, clean, level, dry and non-slip - There must be sufficient walking and moving space to operate the machine

Dangers, requirements and safety measures for (column) drilling machines

VCA (SCC) Final objectives | Page 35 of 66