G74 Gasket Maker TDS 2017
TECHNICAL DATA SHEET FOR LOCKFAST G74
TYPICAL HEAT RESISTANCE
DIRECTIONS FOR USE
HOT STRENGTH Tested at temperature
1. For optimum performance surfaces should be clean and free of grease. 2. If the material is an inactive metal consider using activator. 3. Shake the product thoroughly before use. 4. Apply several drops to the bolt & nut. 5. Assemble and tighten as required. 6. To prevent the clogging of the nozzle, do not let the tip touch metal surface during application.
Remove with standard hand tools.
2. In circumstances where hand tools do not work, use localized heat to bolt or nut, disassemble while hot.
HEAT AGING Aged at temperature indicated and tested at 22°C
1. To remove cured product, use a combination of solvent and abrasion such as a wire brush.
1. Use proper ventilation, avoid contact with skin and eyes. 2. If contact with skin occurs, rinse with warm water or dissolve gradually with appropriate debonder. 3. Do not try to remove forcibly. 4. If adhesive gets into eye, keep eye open and rinse thoroughly. Seek medical attention immediately. 5. Keep well out of reach of children. STORAGE Keep adhesive in a cool, dry place optimal storage 8 C-21 C, is recommended unless otherwise labelled. To prevent contamination of unused material, do not return any product to its original container. For specific shelf life information, contact Adhesive Dispensing Ltd. Disclaimer: The data contained herein are furnished for informational purposes only and are believed to be reliable. However, Adhesive Dispensing Ltd does not assume responsibility for any results obtained by persons over whose methods Adhesive Dispensing Ltd has no control. It is the user’s responsibility to determine the suitability of Adhesive Dispensing Ltd products or any production methods mentioned herein for a purpose, and to adopt such precautions as may be advisable for the protection of property and persons against any hazards that may be involved in the handling and use of any Adhesive Dispensing Ltd products. Adhesive Dispensing Ltd specifically refutes all warranties express or implied, including warranties of salability and suitability for a purpose arising from sale or use of Adhesive Dispensing Ltd products. Adhesive Dispensing Ltd further refutes any liability for consequential or incremental damages of any kind including lost profits .
CHEMICAL / SOLVENT RESISTANCE Aged under conditions indicated and tested @ 22 °C. % of initial strength Environment °C 100 h 500 h 1000 h Motor oil (MIL-L- 46152) 125 100 100 100 Gasoline 22 75 75 75 Water/Glycol 50/50 87 85 85 85 This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be use with chlorine or other strong oxidising materials. For information on the safe handling of this product, consult the Material Safety Data Sheet, (MSDS). Where washing systems are used to clean the surfaces before bonding, it is important to check the compatibility of the washing solution with the adhesive. In some cases these solutions can affect the cure and performance of the adhesive. This product is not recommended for use on certain plastics. GENERAL INFORMATION
Made with FlippingBook - Online magazine maker