TPT November 2009

... Make contact with more than visitors! 77,000

Weld cleaning power brush THE weld cleaning power brush by Osborn International, India, is designed especially for the gas and oil pipeline construction industry. It is an aggressive model that runs at high speeds on surfaces for descaling, deburring, removing rust and adhesive residues as well as preparing and cleaning weld seams. With the most commonly used Osborn brush of diameter 171mm and 76 knots, almost 500,000 sharp wire tips per second are applied to the weld seam. These move over the surface at a speed more than 280km/h and thus remove even the smallest contaminants. These brushes are particularly designed for: weld seam cleaning on fillet welds, in constricted openings and slots; non-stock removing; removal of the coating material, which has been applied as corrosion protection, from the exterior of the pipeline tubes; and the problem zones and undercut that arise under the influence of heat and are normally difficult to reach during welding. The removal of cinder and oxidisation is achieved in a complete and efficient manner. It is an excellent cleaning solution for weld seams prior to re-welding. Any welding defects are visible immediately after brushing and can be reworked and an overall improvement of quality is achieved. Osborn International’s weld cleaning power brush is produced from the highest quality materials, thus providing long life and exceptional brushing results. And ultimately, Osborn claims, it can reduce the cost of construction by 30-35%. Depending upon the surface quality required, brushes with the correct wire size can be specified. These brushes are available in normal and high density variations. They are easy to install and operate with all mobile as well as stationary machines. Osborn Lippert India Private Limited – India Fax: +91 240 2552530 Email: sales@osborn-lippert.co.in Website: www.osborn-lippert.co.in

Exhibiting at wire/Tube Düsseldorf? Book your catalogue entry now and save 5% (limited offer)!

1 Maschinen zur Drahtherstellung und Veredelung

1 Maschinen zur Drahtherstellung und Veredelung

1.6.5

1.6.5

1.6.5 Schneiden

1.6.5 Schneiden

SMITH & SONS

Produktkategorien

Our team will be pleased to inform you of your entry options in the official trade fair catalogue of wire/Tube 2010!

Read this magazine online @:

Neureuter Fair Media Office Essen Westendstr. 1 45143 Essen / Germany

Contact: Phone +49.201.36547-238 Fax +49.201.36547-225 Email: wire@neureuter.de tube@neureuter.de

www.read-tpt.com

http://wire.media-entries.com | http://tube.media-entries.com

10_84_1/3Anzeige_wiretube_RL.indd 1

20.05.2009 14:12:53 Uhr