150416_Training documents
ProSteering ®
Reduced Wheelcut Problem description: Turning radius is too big Restricted wheelcut Wheel does not turn enough times lock to lock Checklist: Axle stops set to manufacturers specifications Q: Did verifying correct axle stop settings improve the wheelcut
A: No
Potential cause(s)
Verification or action
Result
Remedy
Reinstall pitman arm to output shaft with the timing mark properly aligned Investigate the next potential cause Completing this procedure has correctly set poppets or plungers Investigate the next potential cause
Follow the original manufacturers service procedure to check the pitman arm / output shaft alignment Complete the original manufacturers procedure to verify correct poppet or plunger settings Follow the original manufacturers service procedure to set the drag link to the correct length
Timing marks are not aligned
Pitman arm / output shaft alignment
Timing marks are properly aligned
Poppet or plunger settings were incorrect
Poppet settings
Poppets or plungers are set correctly and the problem persists Reduced wheelcut problem persists
Call technical support
Misadjusted drag link
Problem resolved
150416_TECHNICAL GUIDE 29
Made with FlippingBook - Online magazine maker