Atos - Registration Document 2016

D Corporate Responsibility D.6

Information about the report

and consolidated for this value. Data Centre and Office totals are then combined. [G4-EN6_D] energy savings (cost savings), and are implemented based upon their merits. Those that are implemented are recorded For offices, individual initiatives are justified based upon •

The cooling purchased through local district cooling schemes, for DC and offices is 0 GJ [G4-EN3_C3] . Atos do not sell electricity, heating, cooling, nor steam to third parties. [G4-EN3_D1, G4-EN3_D2, G4-EN3_D3, G4-EN3_D4]

Detailed information related to G4-EN5 KPI

Detailed information related to G4-EN7 KPI

denominator) produced by the organization, in the same reporting year. The Energy intensity expresses the energy energy consumption during the reporting year (the numerator) by the revenue metric expressed in millions of € (the The Energy intensity ratio is calculated by dividing the absolute [G4-EN5_B] countries within the baseline (all Divisions) during the year (reporting period: January 1 to December 31) under analysis. the baseline scope measured in 2016. Within that scope, the revenue is corresponding to the turn over generated by all For the Energy intensity ratio the denominator for revenues is the complete organization, however, reporting is restricted to the total headcounts registered at the end of the financial year (as For the Energy intensity ratio the denominator for employees is on December 31) for all countries within the baseline. [G4-EN5_B] and fuel oil). [G4-EN5_C] The types of energy included in the intensity ratio are: electricity, gas, district heating, backup generator fuel (diesel (energy required to operate) [G4-EN5_D] . The ratio uses energy consumed only within the organization required per unit of activity. [G4-EN5_A] and fuel oil). [G4-EN6_B] The types of energy included in the energy reductions are: electricity, gas, district heating, backup generator fuel (diesel Atos reports on initiatives that were implemented during the reporting period, and that have the potential to contribute published in its first year). [G4-EN6_C] published are based upon full-year savings and will usually continue over several years (although each initiative is only significantly to reducing energy consumption. As these primarily arise through investment in infrastructure changes, the savings The reduction is calculated as follows: For data centers, where multiple small activities take place • savings are calculated through PUE reductions measured in conjunction with site energy consumption. Detailed information related to G4-EN6 KPI

Infrastructure & Data Management (IDM). The scope of G4-EN7 is the strategic datacenters (DCs) of Atos The electricity consumption avoided due to Power Usage Effectiveness (PUE) improvement in Atos’ strategic datacenters 1.64 in 2015 and 1.69 in 2014. during the reporting period is 2,584,311 kWh [G4-EN7_A] . Their weighted 12 months average PUE was 1.62 in 2016 compared to more efficient in energy consumption in 2016 compared to 2015. The avoided power consumption was calculated by multiplying Because the PUE decreased 2.4%, the DC facilities were 6% the overall 3.2% average reduction of facility power with the actual facility power of end 2016. reduction (in %), new PUE after reduction: Initial data required: Current IT Load (kWh), Current PUE, PUE current IT load x 730 x 12 months x current PUE; (a) Calculation of the kWh per year before PUE reduction= • current IT load x 730 x 12 months x new PUE; (b) Calculation of the kWh per year after PUE reduction= • kWh saving per year = (a)-(b). • the geographical scope can progressively change to include The base year is the reporting period (January 1 to December 31). Considering the external growth of the Company, additional countries. [G4-EN7_B]. entire site infrastructure divided by the kWh consumed by the IT infrastructure. The PUE, a measure defined by the Green Grid, is The PUE is a standard calculation: total kWh consumed by the the industry standard indicator used to measure and monitor the energy efficiency of a Data Center. [G4-EN7_C] . Detailed information related to G4-EN15, G4-EN16, G4-EN17 and G4-EN18 KPIs The base year is the reporting period (January 1 to December 31). Considering the external growth of the Company, additional countries. [G4-EN15_D] the geographical scope can progressively change to include Scopes (scope 1, 2, 3). The Greenhouse Gas (GHG) Protocol, developed by World Resources Institute (WRI) and World Atos is applying the GHG protocol methodology for all GHG greenhouse gas emissions. [G4-EN15_E, G4-EN16_D, G4-EN17_F, G4-EN19_D]. Business Council on Sustainable Development (WBCSD), sets the global standard for how to measure, manage, and report

. [G4-EN16_B]

The gases included in G4-EN16 - scope 2 are CO 2

The gases included in the calculation of Gases included in G4-EN15 a (CO 2 ) - scope 1, in G4-EN17 a (CO 2 ) - scope 3, and

G4-EN18_D, G4-EN18_B, are CO 2 .

Trusted partner for your Digital Journey

108