326 / 488
326
IEC Motors
DC Motors
Gearmotors
AC / DC Controls
Accessories / Kits
Mods / Factory
Options
X-Ref / Index
Tech Information
Terms / Warnings
Gearmotors
PE350 Series - Parallel Shaft - DC
SCR Rated - 25-371 In-Lbs Torque
Low Voltage - 155-341 In-Lbs Torque
General Specifications - SCR Rated Gearmotors:
• Performance matched for continuous duty service over 60:1 speed range
• Constant torque throughout the range when powered by a full-wave unfiltered SCR-type adjustable
speed control having a typical form factor of 1.3 to 1.4
General Specifications - Low Voltage Gearmotors:
• Performance matched for continuous duty service
• Designed for battery power or can be used with a low voltage controller with form factor up to 1.05
Features:
• Rugged die cast aluminum gear housing for maximum gear and bearing support
• Precision machined gearing, hardened for maximum load capability
• All gearing designed and rated to AGMA class 9 standards, and to withstand momentary shock
overload of 200%
• Oversized output bearings for greater overhung load capacity and long life
• High carbon alloy output shaft provides maximum strength and rigidity
• All needle bearing journals are precision ground after heat treating to provide maximum
fit and finish
• Heavy duty industrial oil seals keep lubricant in and dirt out
• Gears and bearings are splash lubricated with permanent, heavy duty gear oil
• Optional conduit box available, see page 350
Application Notes:
• These gearmotors are designed for mounting at any angle, but motor below the reducer should be
avoided to prevent leakage of lubricant into the motor should the motor shaft seal fail
• Motor’s stall torque could exceed recommended full load torques. A current limiting device such as
an SCR control should be used to prevent damage. This issue is even more critical for low voltage
motors, typically no controller is used since motor is connected directly to a battery, so some type of
current limit or fusing should be considered
• Overhung load capacities shown are at center of output shaft
•
Bodine/Baldor direct interchange