559 / 1618
3/37
Clamping
Systems
3
Articles marked ◊ are not held in stock, procurement is effected at short notice.
The seat belt for your tools
COOL FLASH
Cooling taken to extremes
According to the motto "Making the Good Even
Better", HAIMER has developed the new
COOL FLASH
SYSTEM
for shrink-fit holders on the basis of the
existing Cool-Jet. The coolant lubricant emerges
through several slots, slides along the cutter and cools
to the cutting edge of the tool!
COOL-FLASH advantages:
• Optimum jet guidance to the cutting edge
• Up to 100% longer life
• No more balls of chips on the tool
• Even at high speeds
• Optimum spinning! No longer out of balance!
No disturbing contours!
• Low cost and subsequent installation is possible
In high-performance cutting (HPC) it can happen that
the tool is pulled out of the chuck. This is due to a slow
micro creep motion. It occurs during machining with
high torque and high attractive forces. Even chucks
with extremely high holding force cannot prevent micro
creep. This can turn high quality workpieces into scrap.
The
SAFE-LOCK™
-system provides a remedy. Driver
elements in the chuck engage in grooves on tool shank.
In addition to the frictional clamping forces of the shrink
fit chuck, the tool is held positively. Thus, micro-creep is
effectively prevented and your tool holds.
Safe-Lock
TM
advantages:
• For high-performance clamping
• Highly accurate tension due to shrink technology
• High torque due to positive transport technique
• No loss in accuracy
• No stripping of tool
• No damage to workpiece and machine
• The groove at the milling shaft is designed in a
manner that the milling tool is pulled into the chuck
(depending on the turning direction)
• Patent registered: licensing possible
559