228 / 1070
Main Office: 405-631-9701
228
Fax: 405-631-0585
E
|
WATERHEATERS
INSULATED HOT WATER STORAGE TANKS
Features:
•
Meets ASHRAE 90.1b Current Standard. A.S.M.E. CODE HEATERS.
•
2" Non-CFC Foam Insulation
.
•
Vitraglas® Lined Tank
- Bradford White water heater tanks are protected from the corrosive
effects of hot water by an exclusive ceramic porcelain-like coating. Our vitraglas
®
lining
provides a tough interior surface for Bradford White water heaters, which must withstand the
wearing effects of high volume & high temp. hot water.
•
Flue Damper
- automatic flue damper reduces standby loss, saving money & fuel.
•
Electronic Ignition
- electronic ignition eliminates the constant burning pilot used on other
commercial water heaters. This device results in savings of pilot gas during standby periods.
(115V AC required).
•
Two Magnesium Anode Rods
- employed to provide an extra measure of corrosion
prevention for longer life.
•
Hand Hole Cleanout
- allows inspection of tank interior and facilitates removal of water
heater's principal deterrent to long life-accumulated lime & sediment deposits.
•
Controls
- adjustable electric thermostat to any
temperature up to 180°F.
A recycling Energy
Cut-Off shuts off all gas in the event of an overheat condition.
•
3 Year Limited Warranty
- protects your investment in a quality glass lined heater. If the tank
leaks for reasons of faulty materials,workmanship,or corrosion within the warranty period, the
heater will be replaced with a comparable heater of our manufacture. (Exclusive of all shipping
& reinstallation costs.) Some states do not allow limitations on warranties. See complete copy
of the warranty included w/ the heater.
•
1 Year Limited Parts Warranty
- these quality components are manufactured for us by
industry leaders and will be replaced in the event of failure during the parts warranty period
(exclusive of shipping and reinstallation costs.)
NOTE: 115 Volts Required On All Above Units. Other models available by Special Order Only.
AGA ANSI Z21.10.3 has "America
National requirement that all gas
water heaters have a minimum
recovery rating of 75% thermal
efficiency shown on all commercial
gas water heaters.
A.S.M.E. CODE HEATERS
INSULATED COMMERCIAL HOT WATER STORAGE TANKS
with Hydrojet ® Total Performance Self-Cleaning System
- AT NO EXTRA COST!!! -
NOTICE:
A.S.M.E. CODE WATER HEATERS (ALSO CALLED "BOILER CODE")
Any Commercial Water Heater that is, or exceeds, 200,000 BTUH input or the equivalent size
in Electric Model heaters are required in Arkansas, Kansas, Missouri, & Texas.
Standard models do not meet State Boiler Codes, & will be turned down on inspection by
the Code Administrators.
Locke Supply Co. assumes no responsibility in selecting the proper model heater for
the Contractor's Local Code requirements. This will be the responsibility of the Licensed
Contractor.
DELUXE ENERGY SAVER MODELS
Includes installed T&P Valve, Flue Damper & Electronic Ignition.
Locke
Code
Vendor
Code
NAT &LP Input
BTU
GA Nameplate
Recovtery
Recovery GPH At
Degree Rise
Stg. Cap. U.S.
Gal.
DIMENSIONS IN INCHES
1st Hr. Del.
Gal. At 100°F
Rise
Ht.
Diam.
Top Wtr.
Conn.
Front
HotW
Front CW
Conn.
Top Vent
Ht.
Vent Diam
2"(R) Wtr.
Conn
Gas Conn
Diam
Relief
Valve
40° 100° 140°
E0213
D100L-250-3NA 250,000 227 606 242 173 100 65 30¼ 67 56½ 23½ 75 6 1½ ¾ 1 312
• None of these units are approved for use in Texas •
3 YEAR WARRANTY
A.S.M.E.
ALL WATER HEATERS ARE TO BE SHIPPED, DELIVERED AND
RE
C
EIVED IN THE UPRIGHT POS
I
T
ION ONLY!
180° F
water heaters