2014 Locke Supply Co.

981 / 1070

Credit: 405-631-9756 981
T
|
TOOLS
CONDUIT REAMING DRILL
HEAD
Locke#
T4969 85091 Conduit Reaming Drill
Head
T2386 19353 Replacement blades for
T4969, T4873 & T0190
CONDUIT FITTING
SCREWDRIVER REAMER
Locke#
T4873 85191 Screwdriver Reamer
T2386 19353 Replacement blades for
T4969, T4873 & T0190
"PAL" THIN WALL
CONDUIT REAMER
Locks onto screwdriver, reams & smooths ½",
¾" & 1" thin-wall conduit ends to protect wire
& permit correct installation of fittings. Reams
inside & outside at the same time.
Locke#
T0190 19352 Conduit Reamer
T2386 19353 Replacement blades for
T4969, vT4873 & T0190
BENDER HANDLES
High-strength galvanized steel handles are
threaded at one end. Informative bending
guide on every handle.
Locke#
T0818 51427 ¾" x 38" Handle
T0819 51428 1" x 44" Handle
EMT BOX OFFSET BENDER
• Bends offsets in one easy operation. Insert
conduit, depress handle, release and
remove conduit.
• Makes identical offsets every time
• Depress handle to create offset that
matches the knockout in box.
• Maximum offset of .56" (9/16).
Locke#
T4868 1811 ¾" EMT Box offset
T4869 1810 ½" EMT Box offset
BEND ALL CABLE BENDER
• Bend inside enclosures to the right or left,
front or back
• Machined from 6061 aircraft aluminum
• Your feeders will lie in the lugs
• Bends wire from #3 to 350mcm
• Fits a standard ½" ratchet.
Locke#
T4134 77455 Cable Bender
LASER PLUMB BOB
Enables you to lay out
overhead work on the
ground and then quickly
transfer the measurements
to the ceiling. Easy to set
up and operate.
• Solid brass construction
• Self leveling and aligning (vertically)
• Durable plastic carry case
Locke#
T4133 88455 Laser Plumb Bob
CONDUIT REAMERS, BENDERS & TOOLS
PIPE VIPER PVC CONDUIT
BENDER
The PVC Pipe Viper is a Bending Spring.
When inserted into a PVC Pipe, it will bend the
pipe leaving no adverse effect to the pipe. The
PVC pipe Viper will allow the PVC to retain its
original inner diameter. The PVC Pipe Viper
takes only seconds to bend PVC.
Locke# Size
T1090 RSB1/2PVCPB ½"
T1091 RSB3/4PVCPB ¾"
T1092 RSB1PVCPB 1"
EMT HAND BENDERS
Cast-in markings for stub-ups, saddle bends,
back-to-back bends, and head-up or down
bending
Locke#
T0655 840A ½" EMT Bender
T0656 841A ¾" EMT or ½" Rigid
EMT BENDERS
Locke#
T0815 56200 ½" EMT Bender
T0816 56209 ¾" EMT, ½" Rigid
T0817 56202 1" EMT, ¾" Rigid