neocube Operating and installation instructions - model S

1 Unpack the heating insert/disassemble the rear panel

Carefully unpack the heating insert and transport to the site of installation. To start with, lift off the steel rear panel. To do so, remove all four Allen screws (4 mm Allen key).

2

Preparing the connections

If a connection for the combustion air and/or for the flue pipe is required, knock out the pre-perforated holes in the steel rear panel.

Before carrying out steps 3 and 4 above, unscrew the flue pipe connec- ting piece at the required outlet and use the blind cover to close off the unused outlet.

3

Rear flue pipe outlet (Ø 130 mm)

In the case of a rear flue pipe outlet, first insert the flue pipe into the wall lining. Then push the steel rear panel over the flue pipe. When doing so, wedge a piece of cardboard, for examp- le, between the flue pipe and the steel rear panel to prevent scratches (see arrow). The heating insert can then be pushed back and the flue pipe outlet created.

4

Top flue pipe outlet (Ø 130 mm)

In the case of a top flue pipe outlet, first place the top plate on two spacers with a height of approx. 10 cm. Attach the flue pipe to the flue pipe connecting piece through the top plate. The heating insert can then be pushed back and the flue pipe outlet created.

Do not touch the spacers until the covering has been completed.

neocube S – Operating and installation instructions

12