Refrigeration | Air conditioning

Elastomere Kältemittelschläuche Elastomeric refrigerant hoses

with solder connectors and/or flare connectors with SAE union nuts

mit Lötanschlüssen und/oder Bördelanschlüssen mit SAE- Überwurfmuttern

Die elastomeren Schläuche werden in kundenspezifischen Längen bis 20 m gefertigt. Elastomere Kältemittelleitungen sind leicht zu verlegen. Ein Abknicken führt nicht zur Beschädigung. Notwendig ist lediglich das Einhalten/Wiederherstellen des minimalen Biegeradius. The elastomeric hoses are manufactured in customer-specific lengths of up to 20 m. Elastomeric refrigerant hoses are easy to install. Kinking does not lead to damage. All that is necessary is to maintain / restore the minimum bending radius.

Technisch-konstruktive Merkmale: Die Kältemittelschläuche [mit geschlossenzelliger Isolierung] auf Polyethylenbais erfüllen die Forderungen der DIN EN 378-2 Pkt. 5.3.1.4 e) Elastomere. Die Schläuche sind nach SAE-J3062 gefertigt und erfüllen die Anforderungen des Standards SAE-J2064. Die Sperrschicht besteht aus Polyamid und der Druckträger aus Polyestergarn (PET). Die Ummantelung ist aus abrieb- und wetterbeständigem synthetischem Kautschuk (EPDM) gefertigt. Insgesamt gewährleisten 7 Schichten die Funktionalität, die geforderte Permeabilität und Feuchtigkeitseintrittsrate. Die Leitungen wurden den Prüfungen gemäß DIN EN 372-2 Pkt. 5.3.2 unterzogen. Die Isolierung ist mit einer widerstandsfähigen, UV- stabilen Hülle ummantelt. Abmessungen und Toleranzen entsprechen der EN 14313:2015, Tabelle 1 und 2. Das Brandverhalten entspricht der Euroklasse, B L -s1, d0 (schwer entflammbar), klassifiziert gemäß EN 13501-1.

Technical and constructive features: The refrigerant hoses [with closed-cell insulation] based on polyethylene meet the requirements of DIN EN 378-2 point 5.3.1.4 e) Elastomers. The hoses are manufactured according to SAE-J3062 and meet the requirements of the SAE-J2064 standard. The barrier layer is made of polyamide and the print carrier is made of polyester yarn (PET). The cover is made of abrasion and weather-resistant synthetic rubber (EPDM). A total of 7 layers ensure functionality, the required permeability and moisture penetration rate. The hoses were subjected to the tests in accordance with DIN EN 372-2 point 5.3.2. The insulation is covered with a resistant, UV-stable cover. Dimensions and tolerances correspond to EN 14313: 2015, tables 1 and 2. The fire behavior corresponds to the Euroclass, B L -s1, d0 (hardly inflammable), classified according to EN 13501-1.

Made with FlippingBook Digital Publishing Software