AOAC RI ERP E-Book - DS DF

OMAMAN-38 B: Collaborative Study Protocol Expert Review Panel Use Only September, 2017

relative variability (RSD r relative variability (RSD R

) ranged from 1.22 to 6.34% and the between laboratory

) ranged from 2.64 to 13.38%.

INTRODUCTION The definition for dietary fiber adopted by the Codex Alimentarius Commission (CAC) in June 2009) (1) includes carbohydrate polymers that are not hydrolysed by the endogenous enzymes in the small intestine of humans and thus includes resistant starch (RS). This definition also includes oligosaccharides of degrees of polymerisation greater than 3. The decision on whether or not to include these oligosaccharides in the labelled dietary fiber value was left to the discretion of national authorities. A method designed to support the CAC definition was published in 2007 (2), and this method was successfully evaluated in interlaboratory evaluations (3, 4) and approved by AOAC International (2009.01; 2011.25) (3, 4, 5). AOAC 2009.01 allows the measurement of TDF by summing the quantity of higher molecular weight dietary fiber (HMWDF), which included insoluble dietary fiber (IDF) and soluble dietary fiber that precipitates in the presence of 78% aqueous ethanol (SDFP), with soluble dietary fiber that remains soluble in 78% aqueous ethanol (SDFS). Subsequent application of this method to a range of food products and ingredients identified several challenges/concerns: namely, a) an incubation time with PAA plus AMG of 16 h (the digestion step paralleling the incubation conditions employed in AOAC Method 2002.02 for RS)(4). A more likely residence time for food in the small intestine is 4 +/- 1 h (6, 7 and references therein)]; b) most commercially available fructo- oligosaccharides (FOS) contain the trisaccharide, fructosyl- β -(2-1)-fructosyl- β -(2-1)- fructose (inulinotriose) which cannot be measured using a Waters Sugar-Pak ® HPLC column because it elutes with the disaccharide fraction; c) during hydrolysis of products high in non-resistant starch, resistant maltodextrins are produced that are incorrectly measured as DF (6, 7, 8); d) phosphate cross-linked starch (RS 4 , e.g. Fibersym ® ) is considerably underestimated; and e) the long incubation times with PAA/AMG require the incorporation of sodium azide in the buffers to prevent undesirable microbial growth. While the azide concentration employed is low (0.02 % w/v), it is still of a health and safety concern to analysts. AOAC Research Institute ERP Use Only

3