Chemical Technology March 2016

7 / 36

PETROCHEMICALS
COVER STORY
abrasives. They are suitable for clear, volatile liquids as
well as for vacuum service and gas transfer.
Seizing problems can be avoided by using Vanton’s
Sump-Gard® SGK cantilevered, bearingless vertical pump.
This pump features a large diameter, plastic-sleeved, stain-
less steel shaft that eliminates the need for immersing
bearings or bushings, thus enabling the SGK pump to run-
dry for indefinite periods of time. In addition, thermoplastic
pumps will not wick or abrade in the way that plastic-lined
pumps, elastomeric-lined pumps and fiberglass-reinforced
plastic pumps may.
EIM Electric
Mather + Platt is the sole distributer for the EIM range of
pumps. EIMmanufactures the SV range of pumps which are
intended for the transfer and handling of sediment, sludge,
scale and slurries in various fields including the mining,
steel, chemical, cement and ceramic industries. Liquids and
slurries containing solids including clay, bentonite, fly ash,
coke fines, ore, fines and cement, can be pumped because,
unlike in a conventional non-clogging centrifugal pump,
where the impeller is located in the water passage within
the pump casing (with only a narrow clearance between the
impeller and the suction cover) thus increasing the risk of
clogging in this area, in the vortex type pump, the impeller
is recessed in the side of the casing and consequently most
of the water containing solids has free passage. This free
flow is induced by the vortex created by the impeller rotation.
The gap between the impeller and the suction cover is the
same width as the discharge port, allowing the free flow of
solids. As is the case with the non-clogging vane, the solids
being pumped do not pass through the impeller but in the
vortex passage, minimising wear to the impeller.
Conclusion
Mather + Platt pumps are manufactured to ISO 9001 qual-
ity certification backed by computer-aided design and test
facility, all supported by a full spares and service organisa-
tion. “All our pumps are manufactured to ISO 9001-2008.
We have in-house inspectors who inspect the raw castings
before and after machining. Once pumps are assembled,
they are inspected again before despatch,” Dave explained,
remarking that the company’s range of pumps can be relied
upon for years of service under the most difficult conditions.
The company offers officially manufactured spares,
manufacturer-warranted repairs, as well as new pumps
and valves. “Being owned by WPIL enables Mather + Platt
to obtain materials such as Super Duplex for pumping
corrosive water, such as sea water. In addition, we have a
long established business relationship with our suppliers
of electric motors, mechanical seals, bearings, and so on.
This has led to good delivery and assistance from these
suppliers,” said Dave.
For more information on APE Pumps and Mather+Platt,
please contact Dave Johnson, Marketing & Business
Development Manager, Mather+Platt on tel: +27 11 824
4810/079 490 7428, email or
go to
Chemical Technology • March 2016 5