551 / 1618
3/29
Articles marked ◊ are not held in stock, procurement is effected at short notice.
Clamping
Systems
3
Application:
For axial and radial runout control. Turning, grinding, etc. Mounting between
centres. Supplied in wooden case.
Order
No.
Size
3350
Clamping range
mm
Set contents
0005
1
1422.00 ◊
12–26 5 clamping mandrels size 02–06
7 clamping sleeves
12; 14; 16; 18; 20; 22; 24 mm
0010
2
1572.00 ◊
25–55 3 clamping mandrels size 07–09
6 clamping sleeves 25; 30; 35; 40; 45; 50 mm
(W001)
Cartridge mandrel range of products
Design:
CoA small range of products, clamping diameter 12–50 mm, turning range 13–100 mm,
hydraulic. Supplied in wooden case.
Application:
For efficient turning of workpieces over their entire length in one setup with high
accuracy. Designed based on the modular principle, therefore universal exchange of driving
plates and centring points possible. Hydraulic or mechanic pressure
equalisation results in uniform clamping force also in case of uneven
workpiece faces. Workpiece face longitudinal stop by spring-loaded
centring point.
Scope of delivery:
Constant face driver range of
products with 1 base body, 4 driving cutters,
clamping diameters 12 – 20 – 32 – 50 mm and 2 centring points,
diameter A = 6 + 12 mm.
Order
No.
MK
3340
Running direction
0005
3
927.00
Right
0010
3
927.00 ◊
Left
0015
4
949.00
Right
0020
4
949.00 ◊
Left
0025
5
1004.00 ◊
Right
0030
5
1004.00 ◊
Left
0035
6
1148.00 ◊
Right
0040
6
1148.00 ◊
Left
(W311)
Constant face driver range of products CoA
Design:
CoE range of products, clamping diameter 12–50 mm, turning range 13–100 mm.
Supplied in wooden case.
Application:
Ideally suitable for efficient turning of workpieces over their entire length in one
setup with high accuracy. At the same time, a groove or serration can be milled. This can e.g.
save changeover to a vice which translates into savings in time and costs. Designed based
on the modular principle, therefore universal exchange of driving plates and centring points
possible. Mechanic pressure equalisation results in uniform clamping force also in case of
uneven workpiece faces. Workpiece face longitudinal stop by spring-loaded centring point.
Scope of delivery:
Constant face driver range of products with
1 base body, 4 driving plates, clamping diameters 12 – 20, 32 and
50 mm as well as 3 centring points, diameter 12, 20 and 32-50 mm.
Order
No.
MK
3341
Running direction
0005
3
1082.00 ◊
Right or left
0010
4
1112.00 ◊
Right or left
0015
5
1164.00 ◊
Right or left
(W311)
Constant face driver range of products CoE
Driving pin chuck
551