RBL Catalog

430 / 434

430
Website Order Desk
1.800.272.9671
Garage Gear
PATENTED
Clean garage floor prior to placing the
Garage mat on floor, as dirt beneath it
will shorten it’s life span.
• Remove from package.
• Center mat on parking space and
unfold.
• Unfold side panels from middle of
mat.
• Center mat on parking space and
park vehicle on mat.
Installation
Clean mat regularly to remove small
pebbles that may damage or puncture
mat.
If mat should be punctured, it is easily
repaired using the following method:
• from bottom side of mat locate
hole and clean area around the
hole.
Patch with duct tape.
Maintenance
Cleaning
The Tapson Garage Mat is very
simple to clean, using the
following method, and takes
under 2 minutes.
• Drag end of mat approximately
3 feet(1 meter) outside the
garage door.
• Take mat from opposite end at
corners and pull mat over itself
while walking towards the door.
• Once mat is outside, pull it until
it is completely overturned,
emptying its contents outside.
• Pull mat back inside and you are
ready to park again.
• Caution - extremely slippery if
placed on ice or snow
TAPSONGARAGEMAT
The Tapson Garage Mat is constructed of reinforced
polyethylene plastic with a 1 ¼ inch (3 cm) foam rope thermal
welded around the perimeter complete with durable plastic
corners to contain the dirt and water.
• Cuts clean up time to a minimum by containing
mud, water, and slush on the mat.
• Protects the finish of the garage floor from salt,
mud, grease, oil, antifreeze and road debris dropping
from the vehicle.
• Protects
other valuables
stored in the garage from
damage due to slush and snow melt.
Tapson Manufacturing Inc. • Head Office - Grande Prairie, Alberta •
Eliminate the mess in your garage by
parking your vehicle on the
Tapson Garage Mat
CarMat #TAC-18
7’4”x 18’4”(240 cmx 560 cm)
TruckMat #TAT-21
7’4”x 21’4”(240 cmx 660 cm)