7 / 108
F
eatures
V
ol
22 No 1 January/February 2009
T
echnical
A
rticle
Illustration images used this issue courtesy of 3R Software Solutions, AutoForm Engineering GmbH, Bronx/Taylor-Wilson, Bigstockphoto.com,
IMS Messsysteme GmbH, International Tube Association, Messe Düsseldorf GmbH, and Ravni Technologies
99
Designing tube mill rolls: state-of-the-art
software technology for optimization of
cage forming systems
By Mr Albert Sedlmaier, Data M Software, Germany,
and Mr Anton Skripkin, CSoft, Russia
Sometimes the distinguishing factor between
two pieces of software with the same function
is the user interface. It is the job of software to
simplify and streamline complex calculations,
design work and data management, so
usability and an attractive appearance are
key considerations. And in areas such as tube
measurement, defect detection, fabrication,
roll design, and virtual hydroforming, expertly
designed software provides remarkable gains
in efficiency and quality.
48
Established in 2005, the Boru event is a
relative newcomer to the tube and pipe
exhibition circuit. But due to Turkey’s unique
position within two continents – Europe and
Asia – the exhibition has attracted a great
deal of interest in a short space of time.
Taking place from 5-8 March, Boru 2009 has
already confirmed over 150 exhibitors while in
the region of 20,000 visitors are expected at
the show.
88
48
Boru 2009:
Istanbul, Turkey
68
88
Software for Design,
Production & Management
As any marathon runner knows, the last
mile can be the most joyous yet tortuous to
experience. The finish line and victory is in
sight, but endurance is taking its toll, energy is
in short supply but concentration must remain
high. And in the exquisite journey of tube
and pipe production, it is essential that good
products are not undone by a lackadaisical
approach to straightening and finishing.
68
Straightening & Finishing
Machinery