49 / 124
47
SLAB/TRIM SAWS
MODELTC-10 SLAB/TRIMSAWComes with
1
⁄
3
Hp
115V/60Hz motor, power feed, vise, and see-through
hood. (Blade not included.)
600-10-2500. ......... Shp Wt. 66 lbs..............1615.00
EXPORT MODEL TC-10X
Same as above but with 220V 50 Hz motor.
600-10-2500X. ...... Shp Wt. 66 lbs..............1765.00
For slabbing, secure your rock in the vise, push the
button, and the power feed goes from there. You can
slab rocks up to approximately 3
5
⁄
8
" x 6" wide by 6"
long. The vise glides smoothly and accurately on two
stainless steel rails. Vice cross feed is 2". The power
feed has an automatic shut-off switch for safety.
Trimming slabs is also easy. The arbor is centered on
the table so that you can get a 90º perpendicular cut
every time. The stainless steel
5
⁄
8
" arbor shaft has two
sealed ball bearings and extra neoprene seal at the tank
for extra long life. The saw table is 13" x 17" with a
rim around the edge to contain water and sludge while
sawing.
The TC-10 comes with a clear, plastic hood that is
easily installed and removed. Splash from the cutting
blade is contained within, but you can easily check
your progress through the clear hood.
Clean up is easy, too. The table with vise and switches
is hinged at one end, and flips up for access to the cool-
ant tank and sludge removal. There is also a drain at
one end of the tank.
MODEL TC-10 10
″
SLAB/TRIM SAW
This 10" saw makes it easy to trim and slab small rocks. A power feed
mechanism makes slabbing especially easy.
Tank and table is durable aluminum construction with
impact resistant finish for long life. Mounted on a 16"
x 24" laminated baseboard.
This saw requires oil as a coolant. Tank capacity is
approximately one gallon. We recommend Roc-oil.
See page 58.
NOTE: This saw takes a 10" blade with
5
⁄
8
" arbor hole.
To order a blade, see pages 55 to 57.
See page 45 for spare parts or call our Customer
Service for more information.
The Model TC-10 10" saw is attached to a 16" x 24" laminated base-
board. Overall length of the saw is approximately 30" to include motor
and power feed controls.
See page 103 for goggles.
(Included with all Diamond
Pacific trim saws)