23 / 32
21
8.1.3 Preparation of the clutch
for fitment
4
5
6
g
Apply a small quantity of grease (4) in the
hub splines, release bearing internal diameter
and contact with lever, guide tube and clutch
lever contact point (5)
8.1.4 Fitting the clutch
Position the disc over the flywheel
Position the cover, center it using the pins,
tighten three screws by 120° and check that
the disc remains stable and well-centered
using the centring tool
Tighten each screw slightly in a crosswise
sequence. The diaphragm fingers should
move as uniformly as possible. Repeat the
sequence three times
Using a torque wrench, completely fasten
the screws (6)
Mount the release bearing on the guide tube
and check if it slides correctly.
g
g
g
g
g